Print This Page 
Email to Friend
TRADITIONAL WHEEL CHOCK
New patented design. Wheel chock mounting plates snap into E-Track allowing fast, secure mount and
dismount feature. Wheel chocks can be positioned laterally in 2" increments, and 8" of handlebar stagger is
provided by attaching the mounting plates at opposite ends of the wheel chocks. Available as a complete kit,
or mounting plates only to drill and adapt to your own wheel chocks.
Recommended Bolt Pattern 10 Bolts
HORIZONTAL E-TRACK FOR
USE WITH MOTORCYCLE
WHEEL CHOCKS
Track ships U.P.S. in 5' lengths.
#202 . . . . . . . . . . . . .$15.00 EACH
FASTENING HARDWARE
For 3/4" thick plywood floors:
20 pieces of 1/4x20x1¼" Grade 5 bolts, 1/4x20,
locknuts, 1/4"x1½" fender washers #212 . . . . .$8.50
All hardware is zinc plated
For 1-3/4" thick lumber floors:
20 pieces each of 1/4x20x2¼" Grade 5 bolts, 1/4x20
locknuts, and 1/4x1½" fender washers #214 . . .$8.50
All hardware is zinc plated
PATENTED
Stop spending hours bolting permanent “D” rings
and wheel chocks or keyhole fastening slot receiver
devices to the deck of trailers. This type of installation
offers minimal flexibility and wheel chocks can
not be quickly and easily relocated. Wheel Chocks
do not “lock in” and can slide out of keyhole slots
if forward pressure is not constant.
Now, only minutes are spent installing 2 rows of
E-track, 10 bolts per row, through predrilled holes
in the tracks.
Wheel chocks and tie down rings snap securely
into track sections and cannot be removed unless
fingertip actuated release levers are pulled.
Wheel chocks can be mounted left to right anywhere
along a single row of E-track in 2" increments.
Wheel chocks can be snapped in, one attaching at
its front, and the other attaching at its back to
create 8” of stagger so handlebars do not conflict.
Recommended Bolt Pattern 10 Bolts
HORIZONTAL E-TRACK FOR USE WITH MOTORCYCLE WHEEL CHOCKS
Track ships U.P.S. in 5' lengths.
#202 . . . . . . . . . . . . . . . . . . . . . . .$15.00 EACH
FASTENING HARDWARE
For 3/4" thick plywood floors:
20 pieces of 1/4x20x11⁄4" Grade 5 bolts, 1/4x20,
locknuts, 1/4"x11⁄2" fender washers #212 . . . . .$8.50
All hardware is zinc plated
For 1-3/4" thick lumber floors:
20 pieces each of 1/4x20x21⁄4" Grade 5 bolts, 1/4x20
locknuts, and 1/4x11⁄2" fender washers #214 . . .$8.50
*All hardware is zinc plated
